Morso 1400 Instruções de Operação

11 MORSØ JERNSTØBERI A/S . DK-7900 NYKØBING MORS E-Mail: [email protected] · Website: www.morsoe.comA French version of the manual can be downloaded

10Distance to furnitureThe recommended minimum distance from stove to furniture is 30 inches. Note that some furniture is more easily affected by heat

1110 2.0 Operation2.1 Before you start firing For Use with Solid Wood Fuel Only. Do Not Overfire, If Heater or Chimney Connector Glows You Are Overfirin

122.2 Lighting and loading intervalsWhen first lighting the stove, a large volume of air is needed. When the stove is cold, you should leave the door o

1312 Do not for any reason attempt to increase the firing of your heater by altering the air control adjustment range outlined in these directions. War

14 3.0 MAINTENANCE When perfoming maintenance on your stove, always protect yourself, using safety goggles and gloves.3.1 Exterior MaintenanceThe stov

15142. Unscrew the five bolts that secure the glass. (In the event that a bolt sheers off when being unscrewed, remove the remaining body of the b

16Ceramic GasketThe gasket around the perimeter of the door may harden over a period of time. It should be replaced if it becomes difficult to close th

1716Clean the chimney connector disconnecting the sections, taking them outside, and removing any deposits with a stiff wire brush. Reinstall the conn

183.5 Parts diagram for the model Morsø 1410 squirrel124679101112131415171821222324252627282930313275353637383940414344454647495051525354555660616970

19183.6 Parts list for the model Morsø 1410 squirrelPos.No. Parts1 Rear plate, inside 34145100 2 Base plate 44140121 3 Side plate w. squirrel 44

2We congratulate you on your choice of a Morsø stove. Morsø has been producing some of the world’s best stoves since 1853. If you follow this installa

2047 Tightening tape 79074400 48 Stone 79140800 49 Locking device 79127000 50 Cotter pin 79186300 51 Cotter pin 791868 52 Cotter pin

32CONTENTS:1.0 Installation of your Morsø stove 3 1.1 Unpacking the stove 4 1.2 Checking loose parts in the stove 4 1.3 The chimney / flu

4Installation requirements vary in different districts, and the local building officials have the final authorization to approve your installation. You

541.3 The chimney / flue systemNote that the flue system must be independently secured and must not rely on the stove for support. The stove must not be

6Double-wall connectors must be tested and listed for use with solid-fuel burning appliances. Single-wall connectors should be made of 24 gauge or he

76

81.6 Positioning the stoveDistance to walls and lintelWhen the stove is positioned near combustible materials, observe all current local and national

98In the US, floor protection must be constructed of a non-combustible material and installed to extend beneath the heater and 16'' to the fr