Morso 7110 Instruções de Operação

11MORSØ JERNSTØBERI A/S . DK-7900 NYKØBING MORSE-Mail: [email protected] · Website: www.morsoe.comA French version of the manual can be downloaded at

10Note:Acid ProtectionIf acid-washing the masonry around the stove, protect the stove surface with an acid-proof coverFresh Air InletUnless there is d

1110 2.0 Operation2.1 Before you start firing For Use with Solid Wood Fuel Only. Do Not Overfire, If Heater or Chimney Connector Glows You Are Overfiring

12control lever to right position will open the air inlet and will allow a supply of preheated air to enter the firebox via the ‘airwash’ system situat

13124. After the paper/fire lighters have caught fire, leave the fire door ajar about 2-3 cm, so that the chimney draws well. 5. After 5-10 minutes the

147. Place two pieces of fuel weighing roughly 2-4 pound and measuring about 25 cm in length across the embers in one layer, with spacing of roughly

1514 Do not for any reason attempt to increase the firing of your heater by altering the air control adjustment range outlined in these directions. War

16Reasons for dirty glass· Fuel too wet· Logs too large or not split· Combustion temperatures too low Replace broken glass immediately. Do not oper

1716Ceramic glass replacementCeramic glass cannot be recycled because it has a higher melting point that ordinary glass. If ceramic glass is mixed wit

18NOTE: The flame-path equipment, the ceramic rope and the paint finish are not covered by guarantee.All of these service

1918 Caution: Never empty a stove in operation. Never use your household or shop vacuum cleaner to remove ash from the stove; always remove and dispo

2We congratulate you on your choice of a Morsø stove. Morsø has been producing some of the world’s best stoves since 1853. If you follow this installa

203.4 Leaving the stove for extended periodsImportant:If the stove is to be left unused for any period of time, clean it out thoroughly and leave the

21203.5 Parts diagram for model Morsø 7110323635750654055223938529064906486450651641950642042156450536412303016113562352641446287878884415506462415064

223.6 Parts list for model Morsø 7110Pos.No. Parts 1 Base plate 447101xx 2 Front frame 447102xx 3 Door 447103xx 4 Side plate, right 447119xx 5

232250 Screw - 51 Screw - 52 Screw - 53 Screw - 54 Screw - 55 Screw - 56 Screw - 57 Screw - 58 Screw - 59 Screw - 60 Screw - 61 Washer - 6

Morsø Jernstøberi A/S - 19.08.2013 - 72711000

32CONTENTS:1.0 Installation of your Morsø stove 4 1.1 Checking loose parts in the stove 4 1.2 The chimney / flue system 5 1.3 Flue Connecti

4Installation requirements vary in different districts, and the local building officials have the final authorization to approve your installation. You

541.2 The chimney / flue systemNote that the flue system must be independently secured and must not rely on the stove for support. The stove must not be

6Double-wall connectors must be tested and listed for use with solid-fuel burning appliances. Single-wall connectors should be made of 24 gauge or he

76

81.5 Positioning the stoveDistance to walls and lintelWhen the stove is positioned near combustible materials, observe all current local and national

98Distance to furnitureThe recommended minimum distance from stove to furniture is 30 inches. Note that some furniture is more easily affected by heat